• Glued in place with epoxy, these lightweight arbors create a super strong bond between the reel seat and the rod blank that increases sensitivity.  The arbor is a solid, semi-porous polyurethane material that is machined to fit most sizes of reel seats and can be turned down to fit between sizes.  All arbors have a 1/4" inside diameter pilot hole which can be easily reamed or drilled out to fit any rod blank. Click here to see complete notes on custom fitting reel seat arbors.
• Note: as far as we know these arbors will fit only Fuji reel seats.

• The pilot drill bit guides itself through a pre-existing hole in order to increase the diameter.  These tools are made from spade bits with an aluminum pilot on the tip.  When used with a hand drill the result is a perfectly centered hole.  Call for special order sizes not listed below. Click here to see complete notes on custom fitting reel seat arbors.

• Using this jig you can make your own pilot bits for precision drilling reel seat arbors with a 1/4" pilot hole.  It is important to maintain accurate alignment when securing the pilot tube to the tip of the space bit.  This jig is precision machined to maintain this alignment and fit most spade bit sizes available on the market.  This unit comes with six 1/4" diameter by 1" length aluminum pilot tubes.  (Spade bits are available at any hardware supply.)   Click here to see complete notes on custom fitting reel seat arbors.

• Use this abrasive with a rod that will match the desired taper of the rod blank.  Click here to see complete notes on custom fitting reel seat arbors.